February 13, 2016

Instructions

FizzBlaster Home Carbonation Adapter® Instructions

FizzBlaster Home Carbonation Adapter® can be used to add carbonation (CO2) to any liquid to keep it fresh and fizzy. All you need is some basic DIY home brew equipment and the fun can begin.

CAUTION: FAILURE TO FOLLOW INSTRUCTIONS MAY CAUSE INJURY!

Proper carbonation is best achieved when liquids are refrigerator cold. To successfully carbonate, you’ll need to repeat the injection and shaking steps to get the CO2 absorbed into the liquid.

Follow these simple steps for best results.FizzBlaster Cap On Bottle with CO2

Extra safety recommended when using CO2. Gases under pressure can be explosive if handled improperly.

  • ALWAYS check equipment prior to each use: FizzBlaster Adapter, PET bottle, CO2 Tank, Regulator, and Hose.
  • NEVER use on glass bottles or worn PET bottles.
  • ALWAYS use proper CO2 regulators attached to a cylinder.
  • NEVER use more than 30psi (2 Bars) when injecting CO2.
  • ALWAYS wear safety glasses/goggles.
  • REPLACE PET bottles frequently.
  • DO NOT over-tighten the FizzBlaster Adapter.

TO CARBONATE STILL LIQUIDS:

    1. Fill the standard 1 or 2 liter PET bottle with a cold beverage leaving a 2” space at the top.
    2. Attach the FizzBlaster Adapter squeezing the sides of the PET bottle forcing the liquid to the top.
    3. Inject CO2 and remove the ball lock disconnect (Do Not Leave Attached) and shake vigorously.
    4. Repeat injection and shaking process until the PET bottle remains hard.
    5. Refrigerate newly carbonated beverage for 3-4 hours. Repeating the injecting and shaking process will increase the amount of carbonation over time.

TO CARBONATE BEER OR WINE:

      1. Attach the FizzBlaster Adapter to an empty standard 1 or 2 liter PET bottle. Inject CO2 and remove the ball lock disconnect.
      2. Remove the FizzBlaster Adapter from the PET bottle and allow clouding of gas to occur.
      3. Gently pour beer or wine into clouded PET bottle and fill leaving 2 inches of space at the top.
      4. Attach the FizzBlaster Adapter leaving it loose. Squeeze the sides of the PET bottle until liquid flows out, then tighten the FizzBlaster Adapter.
      5. Inject CO2 and remove the ball lock disconnect (Do Not Leave Attached) and shake vigorously.
      6. Repeat injection and shaking process until the PET bottle remains hard.
      7. Refrigerate newly carbonated beverage for 3-4 hours. Repeating the injection and shaking process will increase the amount of carbonation over time.

Download the FizzBlaster Home Carbonation Adapter Instructions